FAQ
Tuning pins/pegs
have been used in stringed instruments for centuries. They change a string’s pitch by winding it around the pin, tightening or loosening the string. They must also hold the string’s tension and prevent slipping.
Harps use two standard types of tuning pins. The first uses screw threads, as seen in zither pins, piano pins, and Dusty Strings’ special threaded-through pins. The second uses friction-held, tapered tuning pins. This older design is common on standard concert pedal harps and many modern folk harps.
The advantages of a threaded pin
it usually only requires one operation of drilling a set sized hole for the pin that is slightly smaller than the pin. Then the pin can either be spun in with a key or drill driver, or hammered in to the desired depth.
The disadvantages of a threaded pin
As you use the harp, the threaded pin cuts threads into the wood. Over time, the pin may become loose and need resetting. In some cases, you may need to fill the hole and drill it again to repair the damage. The pin is also more vulnerable to strong sideways impacts, which can damage the surrounding wood and make repairs more difficult.
When replacing a string, remember to unscrew the pin several turns first. Otherwise, tuning the new string will drive the pin deeper into the hole. This can cause the pins to sit at different heights along the neck. If left unchecked, the uneven heights can pull strings at unusual angles.
The advantages of a tapered pin
If the pin feels too loose, the player can push it farther into the neck while tightening the string. This increases friction and helps hold the pin in place. If the pin feels too tight, loosen the string and push the pin back out from the key side. Then reset it to the desired tension. Unlike threaded pins, Tapered pins allow for these easy adjustments.
The disadvantages of a tapered pin
Installing Tapered pins takes more effort. You need a drill bit to start the holes and a taper pin reamer to shape them. Use a drill press to ream the neck holes, then use the reamer again to fit each pin during final assembly.
Taper pins can vary slightly in size, and harp necks can vary in wood density. Because of this, you will spend more time adjusting each pin to the correct depth and tension than you would with simpler screw-type pins.
Plated pins may also need extra preparation. You may need to sand the middle section of each pin to roughen the smooth surface that sits inside the wood. Modern pedal harps often sandblast this area because their nickel-plated steel pins are especially slippery.
Different kinds of threaded tuning pins.
Two other types of threaded pins are available. The first is the piano pin, which you can purchase from piano supply stores. The second is the Dusty Strings threaded-through pin. These pins work like tapered friction pins but use threads instead of a taper.
Keep in mind that each type of pin requires its own tuning key:
-
Zither pins: .0160" or #10 clock key.
-
Piano pins: Piano tuning key or hammer.
-
Dusty Strings pins: .175" Dusty Strings key, #11 clock key, or Robinson #4 key.
Different kinds or tapered tuning pins
Tapered harp pins come in two different tapers: European taper (1:50) and American taper (1:48). European taper pins are standard on concert pedal harps.
Concert harp pins have the same diameter at the key end. They are roughly equivalent to a #5½ American taper pin.
We don't sell concert pedal harp pins. However, many players replace them with the standard American taper pins we carry in #5 and #6 sizes.


